Product Description
MC Silicone platinum silicone rubber, also known as addition-cure silicone mold rubber, platinums exhibit the lowest
long-term shrinkage (0.01% )and have long library life . The silicone are delivered as two-component liquids, which once
mixed and cured transform into a translucent, elastic and resistant
material. The polymerization can be accelerated by heat.
Features:
Non-toxic food grade
Fast mixing (1:1) with 7000 Cps
High tear and tensile strength
Long shelf life with low shrinkage
Room temperature vulcanized,
Could be accelerated by heat
Easy de-air, no need for vacuum pumping
Application:
1.A range of materials can be cast into the cured silicone mold:
polyurethane and other reactive resins
Small pieces of cement,plaster,gypsum,concrete products.
Food like chocolate,fondants,desserts
Wax,candle,soap;
2.casting body parts, artificial skin, silicone dolls ,shoe insole.
INSTRUCTIONS for addition cure silicone rubber
1. Mixing the two components
According the mixing ratio 1: 1 weighting part A and B, the two
components may be thoroughly mixed either by hand or using a low
speed electric to minimize the entrance of air and to avoid any
temperature increase.
Note: It is also possible to use a special mixing and dispensing
machine for the two silicone components, further information is
available upon request.
2. Molding
The mixture should be degassed preferably at 30 to 50 mbar to
eliminate any entrapped air. If a dispensing machine is used, the
two components are degassed separately prior to mixing. The
silicone mixture expands to 3 to 4 times of its initial volume and
bubbles rise to the surface. The bubbles progressively disappear
and the mixture returns to its initial volume after 5 to 10
minutes. Wait a few minutes to complete the degassing and then
flash the vacuum. The silicone is ready for pouring, either by
gravity or under low pressure.
Note: Flashing the vacuum once or twice accelerates the degassing.
It is recommended to use a container with a high diameter/height
ratio(3 to 4 times of the initial volume)
3. Polymerization
The curing may be slowed down at lower temperature or accelerated
by applying heat.
Note: In general contact with certain materials can inhibit the
cross linking of RTV.
Natural rubbers vulcanized with sulfur
RTV elastomeric is catalyzed with metal salts, e. G. Tin compounds
PVC stabilized with tin salts and additives
Epoxy catalyzed with amines
Certain organic solvents, such as Ketones, alcohols, etc.
In case of doubt, it is recommended to test the substrate by
applying a small quantity of the mixed silicone on a restricted
area.
Packaging & Shipping
Package:
20kg per drum,20kg/drum;480kg/pallet or 640kg/pallet.
200kg per drum, 800kg/pallet
